For security’s sake, when in use of the peanut shelling machine, please be sure to check the machine according to the steps below to avoid accidental injury. The following are the storage precautions of peanut shelling machine:

1. Before using the peanut shelling machine, the operator should check whether the fastener is tightened, the rotating part is flexible, each bearing has lubricating oil and the machine has been placed steadily first. In order to ensure the safety of operating personnel, grounding protection must also be taken on the shell of peanut shelling machine (make reliable connection between the shell and the ground connector with a wire).

2. Idling the peanut sheller for several rounds with manual labor before switching on the power. Identify the reason if there is a crash, then switch on the power.

3. Choose suitable screen according to the peanut size.

4. When switching on the power, the direction of the rotor rotates should be consistent with the direction the machine marks. Idling for a few minutes first to observe whether there is abnormal noise. When the machine is in normal operation, feed the peanuts evenly and continuously with certain amount.

5. The moisture content of peanut is also requested. The peanuts can not be too dry or too wet. If it is too dry, the broken rate of peanut would be higher; while if the peanut is too wet, the peeling rate would be lower.

6. The method to solve the increasing of peanut shells is to move the motor down so as to tense the fan belt and increase the blowing air.

7. Peanut feeding should be uniform and in right amount. Iron, stones and other debris must not be contained in the peanuts in order to prevent broken peanuts and cause mechanical failure. When the peanuts are covered with full screen surface, then turn on the peanut outlet switch.

8. When storing the peanut shelling machine after using, remove the dust and dirt in the appearance and internal residual grain and other debris. Clean each part of the bearing with diesel and spread with butter after drying. Repaint the enameled parts of the peanut shelling machine. The machine should be covered and placed in a dry warehouse. Remove the belt and hang on the indoor wall and away from the sun.