In the process of using nut slicing machine, the working efficiency may decrease, which will not only affect the production progress, but also lead to the increase of production cost. The following are some common reasons and corresponding solutions, hoping to help you quickly locate the problem and restore the normal operation of the equipment.

1.The blade is worn or damaged
Blade is the core component of nut slicing machine. If the blade becomes dull or damaged after long-term use, it will directly lead to the decline of slicing efficiency.
Solution: Check the sharpness of the blade regularly, and polish it or replace it with a new one if necessary.

2.Equipment cleaning is not in place.
Nut chips or grease may accumulate during the use of the nut slicer, which will affect the running speed and cutting effect of the blade.
Solution: After each use, thoroughly clean the equipment, especially the position of the blade and transmission parts, to ensure that there is no residue blocking.

3.The motor power is insufficient
The motor is the key component to drive the nut slicer to run. If the motor is aging, lack of power or line failure, the running speed of the machine may be slowed down.
Solution: Check whether the motor works normally and ensure the power supply voltage is stable. If the motor is found to be abnormal, it should be repaired or replaced in time.

4.Raw material problem
The quality of nuts will also affect the slicing efficiency. For example, peanuts are too dry or uneven in size, which will increase the difficulty of slicing.
Solution: Choose peanuts with uniform size and moderate water content as raw materials. If nuts are too dry, a small amount of water can be sprayed appropriately to increase the humidity.

5.Transmission system failure
The transmission system includes belts, gears and other parts. If these parts are loose or worn, it will also lead to poor operation of the machine.
Solution: Check the transmission system regularly to ensure that all components are closely connected and well lubricated. If serious wear is found, it should be replaced in time.

6.Improper operation mode
The wrong operation mode may lead to the overload of the machine, which will affect the efficiency.
Solution: Operate strictly according to the equipment instructions, avoid putting too much raw materials at one time, and ensure that the machine works within a reasonable load range.

There are many reasons for the decrease of working efficiency of nut slicing machine, which need to be carefully investigated and solved. If the reason cannot be solved after investigation, it is recommended to contact professional maintenance personnel for further maintenance, so as not to delay the production progress.